Fermax MARINE DUOX Manual De Instalador página 12

DUO DUO X MARINE X MARINE
DUO DUOX MARINE DUO X MARINE X MARINE
DUO DUO DUOX MARINE X MARINE X MARINE X MARINE
DUO DUO X MARINE
No es necesario segregar la instalación según ésta jerarquía ya que el sistema se
adapta a las necesidades de la instalación.
NOTA IMPORTANTE:
Programación de parámetros por el instalador.
No es posible configurar la placa de pulsadores por si sola, ya que no se dispone de un
teclado para introducir los valores numéricos. Es necesario conectar temporalmente al
último módulo de pulsadores, un teclado (ref. 7439) para modificar dichos parámetros
(descargar el manual de Programación Placas Direct, cod. 97701, en www.fermax.com).
En configuraciones de Placa DIRECT (con teclado), para la programación de estos
parámetros, debe descargar el mismo manual de nuestra web.
EN MASTER Panel:
•
Programming is always done from the panel activated as MASTER.
•
EAny installation can only have one MASTER panel at a time, whether a single or
multiple block installation, once configured as a sub-block, block or general entrance.
•
A street panel is configured as a MASTER via the SW1 amplifier button. If the SW1
button is pressed 3 times quickly, it is activated as a MASTER panel and a
confirmation tone sounds (beep-beep).
•
When a panel is selected as MASTER, it notifies the rest of the situation and if
another was previously configured, it would automatically stop being so.
•
If there are various blocks in an installation, we recommend using the general
entrance panel as MASTER since it allows you to program all of its telephones.
•
Once having completed the terminal´s configuration, we recommend deactivating
the MASTER panel to avoid accidentally reprogramming terminals.
•
The panel deactivates itself from master mode following the same activation
procedure: 3 quick presses of the SW1 button. A deactivation tone sounds (beep-
bop).
Configuration - Programming the Amplifier
The DUOX amplifier can be configured to allow for the operation as a general entrance,
block entrance or sub-block entrance.
•
The DUOX system uses 6 digit house terminal addresses.
•
These call code digits are organised as follows: BBSSNN:
- BB: indicates the Block number, (from 00 to 99).
- SS: indicates the sub-Block number, (from 00 to 99).
- NN: indicates the sub-Block house number, (from 00 to 99).
You do not have to segregate the installation according to this hierarchy since the system
adapts to the installation´s needs.
IMPORTANT NOTE:
Programming the installer´s parameters.
You can not configure the buttons panel alone, since it does not have a keypad for entering
the numeric values. You must temporarily connect a keypad (ref. 7439) to the last button
module to change these parameters (download the Direct Panels Programming Manual,
cod. 97701) at www.fermax.com.
In DIRECT Panel configurations (with keypad), for programming these parameters, you
Pag 12