1
1
2
2
3 3 3
Main components
1. Nozzle
2. Upper section
3. Buttons
4. Feet
5. Lower section with water container
Use
Place the appliance on a � at, stable surface.
Remove the upper section (2) and � ll the
lower section (5) with clean tap water. The
water level must not exceed the MAX mark. If
required, add 2-3 drops (0.1-0.2 ml) of water-
soluble fragrance oil.
Replace the upper section on the appliance.
Make sure it is attached corrected.
Connect the appliance to a USB power
supply using the USB cable supplied.
Switch the LED light and atomiser on and off
by pressing the appliance's two buttons (3).
If the water container runs dry, the atomiser
automatically switches off .
Unplug the appliance when it is not in use.
Note: Depending on the ambient
temperature and humidity, the water mist
from the appliance may not be visible.
Note: If the ambient temperature is high,
the spray water will collect as water droplets
5
5
around the nozzle.
Cleaning and maintenance
4
4
Unplug the appliance prior to cleaning.
Empty the appliance's water container after
use. Make sure that the water does not run
into the appliance's electronics!
Wipe the appliance and the water container
with a cloth.
Check regularly that the nozzle and the
water intake by the water container are not
blocked. Remove any dirt with a � ne brush.
Do not use harsh or abrasive detergents,
as these may damage the surface of the
appliance.
GB
15