CBX Flex-Seatunit Manual Del Usuario página 11

Fitting the hood: the hood comes ready to use in the box. Attach it by putting the hood clips on
1
to the frame and pressing them together until you hear a "click". Fix the Velcro on the hood to the
prambody.
To remove the canopy off the frame, please open the attached velcro and push the clips upwards
again in order to remove it.
Assembling the bumper bar: place the bumper bar in position by pushing downwards in the
2
direction of the arrows. You hear a „click" sound for right installation. To de-install the bumper bar.
Push the release buttons and pull the bar in the direction of the arrow.
To open the canopy pull it to the front of the seatunit like shown in the picture.
3
The canopy is multifunctional. In order to extend it to XXL size, please open the zip (a) puller.
4
Put the prambody on the fittings on the frame either before or after attaching the bumper bar.
5
When the prambody is fitted correctly you can hear a "click" sound on both sides of the frame.
Take care: always use the prambody rearward facing.
In order to use the seatunit as prambody: push the button of the harness buckle to open it.
6
Remove the shoulderpads from the harness and clap the crotchpad down into the foot area of
the prambody.
In order to use it as a seat unit: You can easily pull the belt of the crotchpad in upward position.
7
The unit will log into seat position, you will hear a "click" for right installation.
The seat unit backrest can be adjusted to three different positions. To adjust the backrest, pull the
8-9
button to move it to the desired position.
Close the clip on backside of the seatunit to have the back in an upright position. The seat is now
10
in seatunit mode and ready to use.
You can remove the seat unit by pushing the release buttons (a) on both sides. Push the release
11
buttons to remove the seat unit upwards. Be careful: The seatunit is now unlocked and not ready
for usage.
Assembling the seat unit: put the seat unit onto the fittings on the frame either before or after
attaching the bumperbar. When the seat unit is fitted you can hear a „click" sound on both sides of
the frame. The seat unit can be used in both directions: forward and rearward facing.
To remove the bumper bar, press the buttons like shown in picture (a).
12
By pressing the middle button of the buckle, you can open the harness system. Put both plastic
13
clamps in the buckle untill you hear a „click". Sound which indicates a correct assembly of the
harness.
Make sure the shoulder belts are positioned correctly over your childs shoulders.
14
To adjust the belt system in length or shorten it tear the belt through the clip.
INSTRUCTIONS
EN
11