Tabla de contenido
Idiomas disponibles
Idiomas disponibles
C7189U REMOTE INDOOR SENSOR
INSTALLATION
Installation Tips
Install the sensor about 5 feet (1.5m) above the floor in an area with good air circulation at average temperature.
Maximum distance between remote sensor and the thermostat is 200 feet. See Fig. 2.
CAUTION
Electrical Hazard
Can cause electrical shock or equipment damage. Disconnect power before beginning installation.
NO
Remote Sensor Wallplate Installation
Remove the cover from the remote sensor as shown in Fig. 3.
1. Pull wires through wire hole.
2. Position wallplate on wall, level and mark screw hole positions with pencil.
3. Drill holes at marked positions, then tap in supplied wall anchors.
4. Place wallplate over anchors, insert and tighten mounting screws. See Fig. 4.
Fig. 3. Remove the cover.
WIRING
The sensor can be used to provide one remote sensor (see Fig. 6) or as a temperature averaging network with
multiple sensors connected (see Fig. 7). The thermostat is not part of the average network.
69-1710EFS—02
NO
Fig. 2. Typical location for C7189U Sensor.
M24056
2
YES
NO
5 FEET
(1.5 METERS)
Fig. 4. Mount wallplate to wall.
M24115
M24057
Tabla de contenido
