Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Warning
• Never connect multiple units of this product in series.
• Never connect the garden socket to an extension cable or
adapter. It must be plugged directly into a mains socket,
otherwise it may overheat.
• Do not use this product with any devices that generate heat.
Risk of re and injury.
• Do not use this product with any devices that are motorised
or any devices that have a rotating component or workpiece.
Risk of injury.
Note – splash proof
This product is protected against moisture and splash water in
accordance with IP44.
4. Setup and operation
Warning
• Only connect the product to a socket that has been approved
for the device. The socket must be installed close to the
product and must be easily accessible.
• Disconnect the product from the network using the power
button – if this is not available, unplug the power cord from
the socket.
• When using a multi-socket power strip, make sure that the
sum power draw of all the connected devices does not exceed
its maximum throughput rating.
• If you will not be using the product for a long period of time,
disconnect it from mains power.
4.1 Remote control
Carefully slide down the battery compartment cover on the rear of
the remote control. Remove the contact breaker. Close the battery
compartment again.
4.2 Setup
• First remove the protective cap from the ground spike.
• Screw the garden socket on to the ground spike.
• Insert the ground spike vertically into rm ground. Make sure
that the ground spike is securely in the ground and cannot fall
over.
• Connect the power cable to a properly installed socket.
• Then connect your device – which must be switched off – to
the socket.
• Now switch on the connected device.
Note – Pulling out the garden socket
• Disconnect the garden socket from the mains.
• Disconnect the power plug of the connected device.
• Pull the garden socket out of the ground using the handle.
4.3 Programming/synchronising the remote control
The remote control needs to be synchronised with the garden
socket before use.
• Press and hold the On/Off button (5) for approx. 7 seconds until
the blue LED (5) ashes.
• Point the remote control at the garden socket and press and
hold the ON button on the remote control until the green LED (7)
ashes quickly.
• When successfully synchronised, the blue LED on the garden
power outlet goes out.
Note
If the synchronisation process fails, the garden socket
automatically exits synchronisation mode after 15 seconds. If
this occurs, repeat the process.
4.4 Operation
• Press the ON button on the remote control to switch on the
connected consumer.
• To switch off the connected consumer, press the OFF button on
the remote control.
Note
If two consumers are connected, these will both be switched on
or off at the same time.
Note: Transmission range
Please note that the maximum transmission range can only be
achieved in optimal conditions. Walls or other wireless signals
(mobile phone, WiFi), for example, may reduce the range.
5. Changing the batteries in the remote control
Carefully slide down the battery compartment cover on the rear of
the remote control. Dispose of the used battery properly and insert
a new A23 battery. Make sure the polarity is correct. Close the
battery compartment again.
6. Care and Maintenance
Note
Disconnect the device from the power supply before cleaning or
if it will not be used for a long period of time.
• Only clean this product with a slightly damp, lint-free cloth and
do not use aggressive cleaning agents.
• Make sure that water does not get into the product.
7. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/mount-
ing, improper use of the product or from failure to observe the
operating instructions and/or safety notes.
a
a
a
a
a
3
Tabla de contenido
