Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OPERATION
Download the PROTO TOOLS APP from the APP store.
Proper Hand Position (Fig. A)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position.
WARNING: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden reaction.
Proper hand position requires one hand on the soft grip
handle
1
.
NOTE: Please take care to apply your manual effort to the
central mark on the handle.
Power ON/OFF (Fig. A)
1. To turn the wrench on and off, press the multifunction
button
.
6
OLED display (Fig. F)
The OLED display shows the user the following important
wrench information.
-
Pass indicator
14
-
Bolt indicator
15
-
Battery level
16
-
Actual torque
17
-
Tightening direction
18
-
Torque target
19
-
GO (ready to work)
20
-
Units
21
-
BLE
22
-
Number of job in sequence
-
Job index
24
Fig. F
16
15 14
24
1A
01/10
100
17
100,0
18
19
Pairing Wrench with a Bluetooth® Device
(Fig. A, G)
1. Remove wrench for the charging dock.
NOTE : Connectivity will not function while the wrench
is charging.
2. Place the wrench and the Bluetooth® device within 3.3'
(1 m) of each other.
3. Turn ON wrench with a short press of the multifunction
button
6
.
NOTE : During power up, the wrench should be placed
on a flat surface to allow auto calibration of the internal
gyro for angle mode. The firmware version number will
be displayed during boot. Wait approx. 2–3 seconds
until the orange status light has stopped flashing and
the main screen is displayed.
4. BLE status light
pairing mode.
5. Open the APP and follow pairing instructions on screen.
6. Once paired the BLE status light
7. Use the APP to control the wrench.
NOTE: Observe the status lights during operation to
monitor the wrench.
NOTE: The Bluetooth® word mark and logos are registered
trademarks owned by the Bluetooth®, SIG, Inc. and any use
of such marks by PROTO is under license.
Fig. G
Monitoring Status Lights During
Operation
Torque Status
Stage
Ready
50-74%
23
75-99%
Target
23
22
Over torque
Wrench Status Light
Blinking orange – startup/calibration
Orange – Battery / Memory / Calibration - check
Red – Battery / Memory / Calibration - attention
Nm
21
BLE light
Flashing – ready to pair
GO
Constant – paired
Modes and Setting
20
The wrench works in Manual mode (offline) when not
connected to the APP.
NOTE: Certain functions are only available when online, or
paired with a compatible device.
Offline Mode
When the wrench is not connected to the APP, this is
referred to as offline mode.
1. The last injected sequence can be repeated, if no sequence
has been injected the wrench is in tracking mode.
2. For details, refer to the in-APP menu.
ENGLISH
flashes to confirm wrench is in
7
7
will be solid.
7
Tightening
Haptic
OFF
OFF
Orange – slow flash
Vibrate - Soft
Orange – fash flash
Vibrate - Hard
GREEN
Click
RED
5
Tabla de contenido
