External Printing; Charging Procedure - CareFusion PulseTrace PCA2 Manual Operativo

External Printing

When printing, the PulseTrace PCA2 will default to an external USB
printer, if connected.
Using the USB cable provided, connect the mini A/B socket on the
right hand side of the PulseTrace PCA2 to the input socket on the
printer. For a list of compatible printers refer to the web site
www.carefusion.com/micromedical or contact your local dealer.
It is recommended that during printing the batteries are on charge
with the unit connected to the mains adapter.
NOTE: Keep the printer out of reach of the patient at all times.

Charging Procedure

The PulseTrace PCA2's internal batteries are discharged when
shipped from the factory and should be fully charged on first use.
Plug the AC adapter into the mains supply and plug the adapter
output plug into the power input socket on the right hand side of the
device. The orange charging light next to the power input socket will
flash to indicate charging and will turn on constantly to indicate full
charge.
The batteries will take approximately 4 hours to become fully
charged.
Note: Use only the AC adapter supplied. Use of any other type may
cause permanent damage to the PulseTrace PCA2 and cause a fire or
electrical hazard. Do not plug in and remove the power lead from
the AC adapter repeatedly.
16