Cleaning And Care - Hkoenig AIR800 Manual De Instrucciones

Control Panel and Buttons
POWER/UV-C: Press this button
to turn on or switch off the unit.
And UV light and Ion generator
also control by this button.
NOTE: Ion generator ON and
OFF with UV lamp at the same
time.
Speed: The fan speed of the unit can be adjusted when the unit is in operation (I = low, II =
medium, III = high). Each time that you press on the (SPEED) button, the speed is adjusted
from L (low) to M (medium) to H (high).
TIMER: By pressing this button, the purifier can be timed to operate for intervals of 2
hours, 4 hours and 8 hours, stopping automatically when the selected operating time has
elapsed. Press this button (Timer) to select the required operating time. A warning light
automatically indicates the remaining operating time. To select the continuous opera-
ting mode, press the button repeatedly until there are no more indicator lights lit up.
Filter Replacement
The POWER light will flashing continuously in GREEN indicating that it is time to replace the filter. Replace the
filter according to the directions then press the POWER/UV-C button and hold for 5 seconds to restart the
system. The light will stop flashing. Filter will last approximately 6 months.
1. Open the front cover from the top.
2. Remove the combination filter by pull the two strips.
3. Insert new Combination Filter into the unit. Consult the strips on the filter for correct installation direction.
4. Reattach the Front Cover of the unit and securely latch into place.
5. Press and hold POWER/UV-C Button for 5 seconds to reset Filter Change Indicator.

Cleaning and Care