How To Drive On A Ramp - NIBBI NTR 450 Manual De Instrucciones

to lift the box
1. Disconnect locking device (A) by
moving it upwards.
2. Pull knob (B) upwards and raise
the box.
to lower the box
1. Press knob (B) and lower the box
until it touches the rubber damper
and then block the box in position
with stop hook (C).
2. Connect locking device (A) by
moving it downwards.
For
tr550d
• To lift the box, move hydraulic le-
ver (A) into "raised" position (B).
• To lower the box, move hydraulic
lever (A) into "lowered" position
(C).

6. How to drive on a ramp

WArnInG
• Select the appropriate speed
before starting to travel downhill
and do not change gear.
• do not park the machine on a
slope.
• If you stop on a slope, make sure
to remove your hand from the
clutch lever. the lever will move
into "braked stop" position.
• drive slowly and use the engine
lock when travelling downhill.
When starting to travel down-
hill, engage the slow speed gear
and move the machine slowly.
An abrupt start could cause the
front part of the machine to rear
up and thus causing an extremely
dangerous situation.
23