ZUMEX Essential Pro Manual De Usuario página 16

Elevation Kit
This Zumex machine has an Elevation Kit to make it easier to clean the surface
where it is located. Elevation Kit ref. 05230* is not included in this model, it is
available in the machine accessory catalogue.
This Kit must be mounted according to the following instructions:
Components
Installation
The machine comes prepared for this Kit to be simply and quickly installed.
1
Place machine in assembly position.
Carefully place the machine on one of its sides, previously protecting this
area to prevent damage to the machine. This operation must be carried
out between two people, so that the base of the machine is in view,
facilitating the work process (see Fig. 1).
Legs 4
Adhesive felt disc 4
Screw-in stud 4
Fig. 1
2
Fit the Elevation Kit legs.
There are four holes on the base of the machine marked in (Fig. 2), where
the legs go. The legs are supplied with some screw-in studs that are
already fitted into the ends of the legs. We must fully insert them into
the holes (A) on the base and then screw the legs in as far as they will go.
Once this operation has been carried out with all four legs, these can be
mounted and removed when required without the screw-in studs coming
out of their housing.
A
3
Put the machine back into its working position.
Carefully stand the machine back up again leaving it in its working
position.
EN
Fig. 2
29