Storage.
If the iSi Siphon is not going to be filled again
immediately, leave the components to air dry
in a clean place and store the iSi Siphon in a
dismantled condition with the measuring tube
inserted. For best results, when not in use, do
not store the siphon with the head screwed on.
Troubleshooting.
Release the pressure
Place the siphon upright in a sink and gently
operate the lever until the pressure is gone from
the iSi Siphon. Now the head can be removed
from the bottle.
If the pressure will not release, please contact
iSi or your service center.
Soda charger will not puncture.
1. The charger being used is not suitable.
2. The charger was inserted backwards.
3. The puncturing unit has been damaged.
Water does not contain any CO
any at all.
1. The siphon was not shaken enough.
2. The water is not cold enough.
3. No pressure/not enough pressure in the
47080601_SMC_GA_kurz.indb 11
Only use original iSi soda chargers.
Insert the iSi soda charger correctly
(see diagram: Instructions for Use).
Send the siphon to iSi or a service center.
After screwing in the iSi soda charger,
shake the siphon vigorously several
times (at least 5 times).
The colder the water, the more CO
it can absorb. For the best results we
recommend keeping the filled Soda
Siphon in the refrigerator.
device.
Only use original iSi soda chargers.
Do not reuse empty chargers. They
should be recycled.
or hardly
2
11
EN
2
08.11.18 15:00
