Technical Data
Voltage
Installation Category
(in accordance with IEC664)
Maximum Current Draw
Maximum Output Power
Speed Readout
Speed Readout Accuracy
Torque Readout Accuracy
Maximum Operating Noise
Motor Type
Drive
Hollow drive shaft
Chuck Guard
Seals
Holding chuck
Protection measures:
Class
0
No additional protection
The operating conditions should be monitored at regular intervals.
Protection device
BDC1850 / 3030 /6015
120 volts @ 60 Hz
II
3 Amps
1/5 hp, 150 watts
LCD 4 digit display
+/- 1 rpm or +/- 1% of reading
+/- 12 N-cm (1 in-lb) or +/- 5% of reading
70 dB(A) at 1 meter
Brushless DC
2 stage transmission
Nitrated P .30 with 10 mm (0.39") diameter
bore for stirring impellers
13 mm (0.51") outside diameter for drive chuck
Length
67 mm, (2.64")
Diameter
54 mm, (2.13")
Molded of clear chemical resistant
polyurethane.
Butyl Rubber
IP 42
3 prong stainless steel. Maximum opening
9.5 mm (3/8") diameter
0
Recommended use
Used only on equipment where failure of the
controls does not represent a hazard.
10
230 volts @ 50/60 Hz
II
3 Amps