Michelin 1126000425 Manual De Instrucciones página 9

EN
Add a few drops of tool oil into the air inlet.
Attach a high flow quick connector filling to the tool.
Empty the magazine.
Regulate the work pressure to obtain the air pressure within the working pressure range at the tool.
Load fasteners into your tool following the instructions in this manual.
Test for proper fasteners penetration by driving nails into a sample piece of wood. If the fasteners do not
achieve the desired penetration, adjust the air pressure to a higher setting until the desired penetration is
achieved. If you are using a tool with a depth control device, turn the thumb wheel for getting the desired
penetration.
WARNING Do not exceed 120 PSI (0.8 Mpa) at the tool.
Disconnect the air supply from the tool before lubricating.
Add a few drops of tool oil into the inlet.
Wipe off excessive oil at the exhaust. Excessive oil will damage O-rings of tool. If in-line oil is used, manual
lubrication through the air inlet is not required on a daily basis.
Turn the tool so the inlet is facing up and put one drop of high speed spindle oil into air inlet. Never use
detergent oil or additives. Operate the tool briefly after adding oil.
Experienced air tool users may find it convenient to use oiler to help provide oil circulation through tool and
increase the efficiency and useful life of the tool. However users must check oil level in the oiler daily.
Many air tool user find it convenient to use a filter to remove liquid and impurities which can rust or wear
internal parts of the tool. A filter also increase the efficiency and useful of the tool. The filter must be
checked on a daily basis and if necessary drained.
ILLUSTRATION SHOWING CORRECT CONNECTION
MAINTENANCE OF THE TOOL
LUBRICATING THE TOOL
LUBRICATING THE TOOL
Quick
Quick
plug
(optional
Quick
coupler
Air
hose
9
Regulator
Plug
oiler Filter
Oiler