Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Concrete Slab (Optional)
If mandated by local code, construct a concrete slab at least
3 in. (76 mm) thick and 6 in. (152 mm) longer and wider
than the unit (34.6 in. (880 mm) X 39.4 in. (1000 mm)).
masonry anchor bolts long enough to retain the unit.
Drill anchor bolt holes into the unit base at the four ideal
locations (F) indicated.
F
B
23.62 in
(600mm)
1/4 in
(6mm)
1.57 in
40
(40mm)
E
Anchor Bolt Drill Location Measurements
A
5.51 in. (140 mm)
B
23.62 in. (600 mm)
C
16.78 in. (426.4 mm)
D
2.55 in. (65 mm)
E
1.57 in. (40 mm)
F
1/4 in. (6 mm) holes
Gravel Base (Optional)
If mandated by local code, clear an area approximately five
inches deep and about six inches wider than the foot print of
the standby generator. Line the area with polyurethane film
and fill with pea gravel or crushed stone. Compact and level
the stone. If concrete slab is required, see Concrete Slab
section in this manual.
5.51 in
A
(140mm)
140
F
F
F
5.51 in
140
(140mm)
16.78 in
2.55 in
426.4
(426.4mm)
(65mm)
C
D
im im
Final Installation Considerations
Engine Oil
NOTICE Any attempt to crank or start the engine before it
has been properly serviced with the recommended oil will
result in equipment failure.
Refer to Maintenance in the operator's manual for oil
fill information.
Damage to equipment resulting from failure to follow this
instruction will void engine and generator warranty.
The engine is shipped from the factory pre-run and filled
with synthetic oil (API SJ/CF 5W-30). This allows for system
operation in a wide range of temperature and climate
conditions. Before starting the engine, check oil level and
ensure that engine is serviced as described in Maintenance
of the Operator's Manual.
The use of synthetic oil does not alter the required oil
change intervals described in the Operator's Manual.
25
Capítulos
Tabla de contenido
