Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TOASSEMBLE T HEHANDLE AND
CRANK ASSEMBLY
1. Cut t ieholding s hift r odtolower
handle a nd move shifter tothefirst
forward g ear.
2. Cutand discard t heplastic t iethat
secures thecrank assembly.
3. Loosen, butdonotremove, the
screws, flatwashers,
Iockwashers,
andhexnuts intheupper holes of
thelower h andle. S ee Figure 3 .
4. Remove thefasteners and the
eye-
bolt from the lower holes of the low-
er handle See Figure 5.
Right Hand Side
Of Upper Handle%
Loosen,
but do not
remove
11/32"
EF{
Flatwasher
5/16" Hex Nut'_ ;;t
5/16"
Screw
5/16" Split
Lockwasher
Figure 3
NOTE:
Make sure the cables
are
not caught
between
the upper and
lower handle.
5.
Raise the upper handle
into operat-
ing position.
NOTE:
if the cables
have become
dis-
connected
form the drive levers,
rein-
stall the cables
as shown
in Figure 4.
Lever
"Z" Fitting
X
6. Install the fasteners that were re-
moved in step 4. DO NOT tighten
until all bolts are in place.
Left Side Of _.\
Upper Handle --4.
Crank
Eye Bolt
f
3/8" Nylon
Locknut
j!i!
\
Flatwasher
Figure 5
7. Attach the crank rod to the universal
joint assembly with the hair pin. See
Figure 6.
8. Tighten nut on eye bolt, Make sure
eye bolt is properly aligned and the
crank can freely rotate.
9. Tighten all handle bolts.
Universal Joint Asser
Crank Rod
Figure 6
Control
Cable
Figure
4
F 041037L
8
Tabla de contenido
