This is a diagnostic charger. The Charger
LED Lights (3) will illuminate in specific order
to communicate the current battery status.
They are as follows:
DESCRIPTION
Battery is charging
Fully charged
Battery is too warm
(remove for approx. 30
min. to allow to cool)
No battery present
Defective battery
(remove and replace
with new battery)
False Defect Note:
When the battery is inserted into the charger,
and the status LED flashes, remove the
battery from the charger for 1 minute, then
reinsert. If the status LED indicates
normal than the battery pack is good. If
the status LED is still blinking, remove
the battery pack and unplug the
charger. Wait 1 minute and plug the charger
back inand reinsert the battery pack. If the
status LED indicates normal than the battery
pack is good. If the status LED is still blinking
then the battery pack is defective and needs
to be replaced.
NOTE When the red indictor flickers, pull out
the battery from the charger and insert again
within 2 hours. If the indictor shows charging,
that means the battery is good. After 2 hours,
please pull out the battery and also pull out the
AC power plug of the charger for 1 miniute, and
then insert the AC power plug and the
battery again. If the indictor shows charging,
that means the battery is good. If not,
the battery needs to be changed.
CHECKING THE CHARGER
If the battery pack does not charge properly:
• Check the current at the power
outlet with another tool. Make sure
that the outlet is not turned off.
• Check that the charger contacts have not
been shorted by debris or foreign material.
• If the surrounding air temperature is not
normal room temperature, move the charger
and battery pack to a location where the
temperature is between 7 ˚C and 40˚C .
LED STATUS
●
Red
●
Red
●
Red
●
Green
●
Red
●
Orange
●
Red
○
OFF
●
Red
☼
Red
blinking
If the battery is inserted into the charger
when warm or hot, the CHARGING LED
indicator light on the charger may switch
on and illuminate ORANGE. If this occurs
allow the battery to cool outside of the
charger from approximately 30 minutes.
CHARGER MOUNTING
• This charger can be installed hanging on
a wall using two screws (not supplied).
• Locate the placement for the
charger to be wall mounted.
• If fastening to wood studs use 2 wood screws.
• Drill two holes 2 3/8" (6 cm) on
center ensuring they are level.
• If fastening to drywall use wall anchors and
screws to secure the charger to the wall.
NOTE If the battery and the charger won't be
used for a long time, please remove the battery
from the charger and pull out the AC power plug.
IMPORTANT SAFETY INSTRUCTIONS
• SAVE THESE INSTRUCTIONS -
DANGER: TO REDUCE RISK OF FIRE
OR ELECTRIC SHOCK CAREFULLY
FOLLOW THESE INSTRUCTIONS.
• Confirm the voltage available at each
country location before using the charger..
6. CLEANING
To avoid risk of fire, electric
shock, or electrocution:
• Do not use a damp cloth or detergent
on the battery or battery charger.
• Always remove the battery pack before
cleaning, inspecting, or performing
any maintenance on the tool.
EN - 4
Capítulos
