Bestron DT48C Manual Del Usuario página 33

7. Now connect the wires to the terminal block on the mounting plate in the following way (G):
• Blue wire → N
• Brown or black wire → L
• Earth wire (yellow-green) →
MONTAGE - Installing the down rod onto the motor
H
1. Remove the cotter pin and metal pin from the down rod (see figure H).
2. Lead the down rod through the canopy (I).
3. Untighten the two screws on the motor (J).
4. Remove the cable binder from around the wiring and lead the wires through the down rod (K). Make sure
not to damage the wiring in the process.
L
5. Reinstall the metal pin into the down rod (L) en secure it by reinsterting the cottor pin (M).
6. Tighten the two screws on the motor (N).
The down rod has now been installed correctly.
MONTAGE - Installing the fan blades onto the motor
1. Remove the two screws from one of the red plates on the motor (see figure O), place a fan blade (white
side up) on the red plate and tighten the screws (P). Make sure to keep the red plate between the fan
blade and the motor.
2. Repeat the process for the other two fan blades.
I J
M
33
EN
K
N