Troubleshooting - Teac SL-D950 Manual Del Usuario

If you have problems with your system, look through
this chart and see if you can solve the problem
yourself before calling your dealer or TEAC service
center.
General
No power
e Check the connection to the AC power supply.
Check and make sure the AC source is not a
switched outlet and that, if it is, the switch is
turned on. Make sure there is power to the AC
outlet by plugging another item such as a lamp or
fan into the outlet.
e Set the POWER switch on the rear panel to ON.
No sound from speakers.
e Select the source by pressing the FUNCTION
button.
e Adjust the volume.
e Pull out the headphone's plug from the PHONES
jack.
e If the MUTING indicator lights on the display,
press the MUTING button.
The sound is noisy.
e The unit is too close to a TV or similar appliances.
Install the unit apart from them, or turn them off.
Remote control unit does not work.
e If the battery is exhausted, replace it with a new
one (see page 12).
e Use remote control unit within the range (5 m)
and point at the remote sensor on the front
panel.
e Clear obstacles between the remote control unit
and the main unit.
e If a strong light is near the unit, turn it off.
CD Player
Cannot play.
e Load a disc with the label side up.
e If the disc is dirty, clean the surface of the disc.
e A blank disc has been loaded. Load a prerecorded
disc.
e Depending on the disc, etc. it may not be possible
to play back CD-R/RW discs. Try again with
another disc.
e You cannot play back unfinalized CD-R/RW discs.
Finalize such a disc in a CD recorder and try again.

Troubleshooting

Sound skips.
e Place the unit on a stable place to avoid vibration
and shock.
e If the disc is dirty, clean the surface of the disc.
e Do not use scratched, damaged or warped discs.
iPod Player
Cannot insert the iPod.
e Check the dock adapter (refer to the instructions
of DS-22.)
e Remove dust or obstacles from the Dock
connector of the DS-22 and the iPod, and insert
the iPod again.
Will not play.
e Remove the iPod from the dock, wait a few
seconds, and insert it again.
e Software update may solve the problem. Visit the
Apple website and download the latest iPod
Software (see page 9).
Cannot operate the iPod.
e Set off the HOLD switch of the iPod.
Tuner
Cannot listen to any station, or signal is too
weak.
e Tune in the station properly.
e Rotate the FM or the AM antenna until you get
stations clearly.
If normal operation cannot be recovered, set the
POWER switch to OFF then return it to ON, or
unplug the power cord from the outlet and plug
it again.
33