Face Plate; Extension Bed - LEMAN TAB085 Manual De Instrucciones

VARIABLE SPEED WOOD LATHE
Faceplate Installation
Remove the headstock spur from the

spindle by using the push-out rod.
Thread the 4" diameter faceplate

onto the spindle and tighten with the
supplied wrenches.
Mount your

faceplate using flat head brass
screws. Be certain that the ends of
the screws will not interfere with your
planned turning.

Extension Bed

The extension bed is attached to the

left of the headstock for outboard
faceplate turning when the use of the
articulated tool rest is required.
If outboard faceplate turning does

not require the use of the tool rest,
do not attach the extension bed until
required.
To attach the extension bed (1) to

the lathe bed, align the bolt holes (2)
with the threaded bed holes (3).
Install a lock washer (4) onto an Allen bolt (5).

Finger tighten and then secure tightly with the Allen key provided.

DO NOT ATTEMPT TO OPERATE YOUR LATHE UNTIL IT IS COMPLETELY
ASSEMBLED AND ADJUSTED ACCORDING TO THE INSTRUCTION
MANUAL.
Assembly, Continued
workpiece to the
EN
11