Observe During Use; Technical Data; After Use - Dräger SPC 4800 Instrucciones De Uso

4 Use
4.1 Prerequisites for use
The environmental impact must be determined prior to use, since the suitability
of the chemical protective suit must be determined before its use. The chemical
protective suit must only be used for suitable purposes.
4.2 Preparations for use
1. Test the chemical protective suit. Do not use a damaged chemical protective
suit.
Get a second person to assist you with donning the suit.
2. Fasten the full face mask.
3. Step into the trouser legs of the suit (take shoes off first).
4. Put on the protective boots and pull the cuffs down over the boots.
5. Put on cotton gloves if necessary.
6. Put the hood on and pull the face cuff over the full face mask.
Make sure the face cuff is pulled tightly over the full face mask and that
there are no loose folds.
7. Close the zip fastener and the covering flap.
8. Put on the powered air purifying respirator, air line breathing apparatus or
self-contained breathing apparatus.
9. Connect a respiratory filter, a powered air purifying respirator, air line
breathing apparatus or self-contained breathing apparatus to the full face
mask.
10. When using laminate gloves, wear overgloves too.
4.3

Observe during use

CAUTION
A build-up of heat in the chemical protective suit can cause a circulatory
collapse.
► Wear a Dräger comfort vest underneath if necessary.
– Observe the period of use, operation limits and specific national regulations.
The maximum deployment duration also depends on the type of breathing
apparatus used.
– In case of emergency, leave the contaminated area immediately. Open zip
in clean area only.
4.4

After use

4.4.1 Precleaning the chemical protective suit
WARNING
Risk of contamination!
► Only touch contaminated parts with protective clothing.
1. Leave the contaminated area and have the chemical protective suit
precleaned with the aid of a helper. The helper must also wear protective
clothing, and breathing apparatus where necessary. For precleaning,
Dräger recommends using plenty of water to which a detergent has been
added. This will sufficiently wash away most chemicals (acids, alkalis,
organic and inorganic substances). Avoid spreading chemicals.
2. In the event of contamination with hazardous substances, dispose of the
waste water in line with the relevant waste water disposal regulations.
Instructions for use |
Dräger SPC 4800
4.4.2 Removing the chemical protective suit
WARNING
Risk of contamination!
► Only take off the chemical protective suit in a non-contaminated area.
1. Disconnect the breathing apparatus from the full face mask, and set down.
2. Get a second person to open the zip.
3. Pull the hood off your head.
4. Take off the chemical protective suit.
5. Remove the full face mask.
5 Transport
Transport the chemical protective suit in its original packaging.
6 Storage
Store the chemical protective suit in a dark, cool, dry and airy place without
pressure or stress and in its original packaging. Keep out of UV light and direct
sunlight; avoid ozone. Observe the permissible storage temperature (see
"General", page 7). If the chemical protective suit is not used and the storage
conditions are adhered to, the chemical protective suit has a life span of
ten years. Observe the different expiry dates of the components.
CAUTION
Failure to observe the storage conditions can result in damage to the chemical
protective suit!
7 Disposal
The chemical protective suit must be disposed of in accordance with the
applicable waste disposal regulations. The chemical protective suit can be
disposed of thermally or on waste dumps. The form of disposal depends on the
contamination.
8

Technical data

8.1 General
Suit material
Glove material
Weight
Size
Temperatures
in usage
In storage
Use
CLF
Butyl or laminate
approx. 800 g
See page 2, figure B
Observe operating temperatures of the
respiratory protective equipment!
-15 °C to +60 °C
|
en
7