Fox Live Valve Guia Del Propietario página 8

KABOLT INSTALLATION
Wheel installation is identical for both the 15x100 mm
and 15x110 mm Kabolt axles.
1. Install the front wheel into the fork dropouts. Slide the
Kabolt axle through the non-drive side dropout and hub.
2. Use a 6 mm hex wrench to torque the Kabolt
axle (clockwise) to 17 Nm (150 in-lb).
TIRE CLEARANCE TEST
1. Release all air pressure from the fork by depressing the Schrader valve.
FOX forks may contain high air pressures. Release ALL air pressure from the main
air chamber before disassembly. Failure to do so may result in parts or fluids
ejecting from the fork, which can cause SEVERE INJURY OR DEATH.
2. Compress the fork completely.
3. Measure the distance from the edges of the inflated tire to the crown, fork brace, and
steerer. There must be AT LEAST 8.5 mm of clearance around the entire tire.
Failure to leave at least 8.5 mm of clearance between the edges
of the inflated tire and the crown, fork brace, and steerer may
cause the tire to jam against the crown when the fork is fully
compressed, which can result in SEVERE INJURY OR DEATH.
4. Add air pressure to your desired setting using a FOX high-pressure pump. Set the sag
according to instructions online at www.ridefox.com.
5. You must repeat this test EVERY time you change tires or rims.
WARNING
Do not exceed maximum air pressure:
32 FLOAT maximum air pressure is 140 psi.
34 FLOAT maximum air pressure is 120 psi.
36 FLOAT maximum air pressure is 120 psi.
Minimum air pressure is:
40 psi for all FLOAT forks.
Pressure measured at an ambient
temperature of 70-75˚F. Normal operating
temperature range for FOX products is
20-140˚F.
WARNING
WARNING
8.5 mm <
8
> 8.5 mm