Tiny Love 3-in-1 Rocker-Napper Guía De Instrucciones página 2

3-In-1 Rocker-Napper
3 Modes of Use: Rock & Play
INSTRUCTION GUIDE
IMPORTANT: READ ALL INSTRUCTIONS BEFORE USING THE PRODUCT.
KEEP THESE INSTRUCTIONS FOR FUTURE USE AS THEY CONTAIN IMPORTANT INFORMATION.
• The maximum weight of the child of which the product is
intended is 40lbs/18Kg.
• This product contains small parts which are for adult assembly
only. Philips screwdriver required (not included).
• Remove all packaging materials before use. Suffocation Hazard.
WARNING: Prevent
serious injury or death:
• Never leave the child unattended.
• This product is not intended for unsupervised or prolonged
• periods of sleep.
• Always use restraint system until child is able to climb in and out of the
product unassisted.
• Do not use this product as a "Napper" when the infant begins to push up
on hands and knees.
• Do not use this product as a "Rock & Play" for a child able to sit up
unassisted.
• The upright position ("seat" mode) is only for children who have
developed enough upper body control to sit up without tipping forward.
• FALL HAZARD: Child's activity may move product, use only on floor.
Never use on any elevated surface.
• SUFFOCATION HAZARD: Never use on a soft surface (bed, sofa, cushion),
as product may tip over and cause suffocation.
• Never use this product without the "Incline support" (Figure J, page 11).
• The toy arm is not a carry handle. Never use the toy arm to carry
the product.
• Toy arm should be removed from the seat when child start to sit
independently. The hole should be covered by its attached cap.
• NEVER lift infant seat with child in it.
• NEVER use infant seat as a car seat.
• Check this product regularly that all assembly fittings are tightened
properly before use.
• Do not use if any parts or screws are loose or missing or if there are any
signs of damage or broken parts.
• Do not substitute, modify or alter parts. Contact the manufacturer if
replacement parts or additional instructions are needed.
• Young children should not be allowed to play unsupervised in the
vicinity of the product.
• Batteries not included. For electronic toy: 3 AAA/LR03 (1.5V). For vibration
box: 1 C/LR14 (1.5V).
For customer service information please visit our website: www.tinylove.com
English
Napper Stable Seat
Other battery information:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickelcadmium) batteries.
• Remove the batteries for long-term storage or periods of non-use.
• We recommend alkaline batteries for longer battery life.
• Non rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the unit before
being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Only batteries of the same or equivalent type as recommended are
to be used.
• Batteries are to be inserted with the correct polarity.
• The supply terminals are not to be short-circuited.
• Check that all contact surfaces are clean and bright before
installing batteries.
• Batteries should be replaced by adults only.
• Exhausted batteries are to be removed from a product.
• Do not burn batteries. Dispose of batteries in a safe and
appropriate manner.
• Install new batteries and retry function before calling Consumer Relations.
Care & Storage:
1. Washing instructions: All fabrics are machine washable.
• Machine wash cold, Mild cycle
• Do not bleach
• Line drying
• Do not tumble dry
• Do not iron
• Do not dry-clean
2. DO NOT submerge other parts of the product in water.
3. Remove batteries when stored for long periods of non-use.
FCC information:
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
RADIO AND TELEVISION INTERFERENCE
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Changes and Modifications not expressly approved by
the manufacturer or registrant of this equipment can void
your authority to operate this equipment under Federal
Communications Commission's rules.
3