Idiomas disponibles
Idiomas disponibles
Caution
Switch off the unit before clean it to avoid dangers.
When the plug or power cord have damage, do
not use the unit, even not to disassembly by
yourself, must be inform the after- service center
to handle.
Special security precautions
• Caution: The blades of the jug are very sharp.
There is a danger of injury! While the blades are
turning, never touch the jug from the inside and
never put any objects inside.
• Only use equipment endorsed by the
manufacturer.
• Only use the unit with tightly closed lid and
inserted closure.
• The unit is equipped with a security function.
The unit can only be switched on if the jug is put
on the engine base properly. If the unit cannot be
switched on, pull the power cable and check the
connection between jug and engine base.
Installation
1. Clean the measuring cup, cover and jar (except
main body) and so on before first using.
2. To make sure the unit is turned off and not to
connect before installation.
3. First ring the jar sealed ring into blade base,
then enclose the blade base into jar, last rock the
jar slightly causing it to lock into place.
4. Fit the blender glass jar onto the main body,
and turn it slightly in a clockwise so it locks with
the motor section. Fill the jug with the desired
foods. Please ensure the water not spill over from
cup. ( Maximal water capacity can not exceed
1500 ml)DO NOT USE THE UNIT WITHOUT ANY
MATERIAL INSIDE.
5. Put the cover on top of the jar and push it
down. Insert the closure into the cover and turn
till it locks into place.
6. Place the measuring cup on the center of cover,
anticlockwise rock the measuring cup slightly.
Operation
1. Connect the power. Please ensure the knob
turn to "OFF" before connect the power. The
blue light of the knob will light for one second,
which means power well connected.
2. This unit has safety design. It does not work
if the jar is not installed on main body properly.
3. Fill the jug with the desired foods.
4. Put the cover on top of the jar and fix it.
Place the measuring cup on the center of cover,
anticlockwise rock the measuring cup slightly.
5. Put the jug on main body upper base.
6. Turn the knob to position "On", blue light
around the knob is on.
7. The functions of"SMOOTHIE" (milk shake)
"ICE" "PULSE"are available; Press one of the
buttons. That button will light and the machine
will work in corresponding mode.
8. For choosing the speed, please turn the knob
between "MIN"(lowest speed) and "MAX"(highest
speed) to choose the required speed.
9. Please stop working after operating continuous
for 2 minutes.
Caution
1. Over-filled can block the operation, please turn
off the unit and do not connect the plug, take out
some of material, then operating.
2. Do not use the unit continuously more than 2
minutes.
Cleaning and storage
• In addition to this, you must refer to the security
precautions.
• Do not clean Motor main body, power cord and
plug with water.
• Clean the engine base with a soft, wet piece of
cloth and some mild cleaning agent.
• Fill the jug half-full with hot water and a little
cleaning agent. Let the unit run on speed 2 until
the jug is clean.
• The base with the blades can be taken apart.
Screw of the base counter-clockwise. Take out
the blades together with sealing ring facing
upwards.
• Now clean jug, lid, closure, base and blades with
sealing ring with hot water and some cleaning
agent. Dry well before re-using. Caution! The
blades inside of the jug are very sharp.
• Never use aggressive cleaning agents.
