Metal Works CAT990 Manual página 19

CAT990 - NLFRENES - v1.0 - 19082013
EN
STEP <1>
Step 1
1.Please upend the bracket (#8), use M8*20 hex bolt(match faced washers, spring washers) to pass leg
STEP <1>
1. Please upend the bracket (8), use M8x20 hex bolt (match faced washers, spring washers) to pass leg A (3 pcs), leg
A (3pcs), leg B (#10)(1PC), then mount on the bracket as figure showed. Please take care the deposited
B (10)(1pc), then mount on the bracket as figure showed. Please take care the deposited position and direction of leg
1.Please upend the bracket (#8), use M8*20 hex bolt(match faced washers, spring washers) to pass leg
position & direction of leg B(#10)
B (10)
A (3pcs), leg B (#10)(1PC), then mount on the bracket as figure showed. Please take care the deposited
2.Please use M8*20 hex bolt and faced washers, spring washers to pass leg reinforce 1,2. then mount
2. Please use M8x20 hex bolt and faced washers, spring washers to pass leg reinforce 1,2. Then mount on the bracket
position & direction of leg B(#10)
as figure showed. on the bracket as figure showed.
2.Please use M8*20 hex bolt and faced washers, spring washers to pass leg reinforce 1,2. then mount
on the bracket as figure showed.
Step 2
Please place assembling parts of Step 1 to position as figure, then put the big funnel in the middle.
STEP<2>:
Please note: The front big funnel should be put to face leg B.
Please place assembling parts of Step <1> to position as figure, then put the big funnel in the middle.
STEP<2>:
Please note: The front big funnel should be put to face leg B.
Please place assembling parts of Step <1> to position as figure, then put the big funnel in the middle.
Please note: The front big funnel should be put to face leg B.
Page 5 of 12
Page 5 of 12
®
19