Tabla de contenido
Idiomas disponibles
Idiomas disponibles
MF Control
11 Disassembly
NOTICE
• Observe the information provided in the following section:
8 Decommissioning on page EN-9
1 Disassemble the MF Control as follows:
Fig. 5
Disassembling the MF Control
12 Disposal
When disposing of the system, local regulations, laws, provisions, standards and guidelines must be observed. Observe the
regulations on the disposal of electronic scrap and dispose of it at your local waste disposal site (e.g. recycling centre).
To correctly dispose of the product, it must first be disassembled. Please take note of the following information:
See 11 Disassembly on page EN-11
12.1 Materials
This product is mainly made of metallic materials, which can be melted in steel and iron works and are thus almost infinitely
recyclable. The plastic materials used are labelled in preparation for their sorting and separation for later recycling.
12.2 Consumables
The control system does not require any consumables. However, please consult the operating instructions for the other
welding components.
12.3 Packaging
ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle packaging
materials is always considered during their selection.
BAL.0532.0 • 2018-08-16
B
A
11 Disassembly
EN - 11
Capítulos
Tabla de contenido
