HSM SECURIO P 44 Instrucciones De Servicio página 14

5 Operation
WARNING
Before switching the machine on,
make sure that you observe all safety
instructions.
Switching on the shredder
• Only US-version: Set mains switch at rear of
paper shredder to „I".
• Check that no paper is in the paper feed slit.
• Press the on/off button.
 The "Ready for operation" indicator lights up.
Shredding paper
• Paper thickness measurement PAPERcon-
trol
The document shredder features an inte-
grated paper thickness measurement. This
allows you to check whether a stack of paper
can be shredded in a single go.
Slide the stack of paper into the control slot.
After a short time lag, the display on the op-
erating control lights up:
in green: The stack of paper can be shred-
ded.
in yellow: The amount of paper is within the
machine's upper capacity range.
Reduce the number of sheets in
order not to damage the machine
and prevent a paper jam.
in red: The number of sheets exceeds
the maximum cutting capacity of
the machine. Prevent the cutting
unit from blocking by reducing the
amount of paper.
Remove the stack of paper.
• Feed the paper to the middle of the paper
slot. The light barrier starts the cutting unit
automatically. Therefore, with thin paper
strips, make sure the light barrier detects
them.
Note: Do not shred paper in the CD cutting
unit. This can cause damage.
 3 seconds after the light barrier in the paper
feed opening is free again, the cutting unit is
switched off automatically and the shredder
switches to standby.
14
Destroying CDs / USB sticks / credit
cards / fl oppy disks
• Check whether your machine is certifi ed for
destroying these materials (see "Intended
use").
• For machines with a separate CD cutting
unit (optional), put CDs, diskettes and credit
cards in the feed slot of this cutting unit. This
protects you from splinters. Otherwise, use
the paper cutting unit.
• Always use the paper cutting unit to destroy
USB sticks.
Switching off the shredder
• Press the on/off button.
 The "Ready for operation" indicator goes out.
• Only US-version: Set mains switch at rear
of paper shredder to „0".
Other function modes:
• Permanent mode
Application: Destroying large quantities of
paper
Function: Cutting unit runs continuously.
If no material is fed in within a period of
2 minutes, the cutting unit shuts down and
the shredder switches to standby.
Start: Press the on/off button for at least
4 seconds.
To cancel: Press the on/off button.
• Stand-by mode
Function: Two minutes after the last paper
feed operation, all consumers that are not
required are switched off automatically.
The "Ready for operation" indicator goes out
briefl y at regular intervals.
The shredder starts automatically when pa-
per is fed in.
SECURIO P 44
english
12/2014