Kobalt KDD 524B-03 Manual De Uso página 11

OPERATING INSTRUCTIONS
8. Installing and Removing the Belt Clip
a. Align the rib of the belt clip (H) with the hole on the
base of the driver.
b. Insert the screw (J) and tighten the screw securely
with a Phillips screwdriver (not included).
c. To remove the belt clip, use a Phillips screwdriver to
loosen the screw holding the belt clip to the driver.
9. Installing and Removing the Bit Holder
a. Align the rib of the bit holder (I) with the hole on the
base of the impact driver.
b. Insert the screw (J) and tighten the screw securely
with a Phillips screwdriver (not included).
c. To remove the bit holder, use a Phillips screwdriver
to loosen the screw holding the bit holder to the
driver.
10. Auxiliary Handle
This drill/driver is equipped with an auxiliary handle
(G). For ease of operation, you can use the handle
with either the left or the right hand. The handle can be
rotated 90° and locked in any of three positions.
To install the auxiliary handle:
a. Place the direction-of-rotation selector (E) in the
center lock position.
b. Loosen the auxiliary handle by turning the handle
counterclockwise.
c. Align the raised portion on the auxiliary handle with
the grooves on gear box of the drill/driver, then slide
the auxiliary handle onto the tool as shown.
d. Hand-tighten the handle by turning the handle
clockwise.
To remove the auxiliary handle:
a. Place the direction-of-rotation selector (E) in the
center lock position.
b. Loosen the auxiliary handle by turning the handle
counterclockwise.
c. Remove the auxiliary handle from the tool.
WARNING
• For safety and ease of operation, securely tighten the
auxiliary handle by turning the handle clockwise before
every use.
8
9
10
E
11
H J
I J
G
kobalttools.com