Function Settings - Trotec TP6 Manual De Instrucciones

10. Function settings

Various functional settings can be applied us-
ing the additional function (mode) selec-
tion button
functional mode each time the mode button is
pressed (see illustration).
H
To set the desired function, press the mode
button
function symbol flashes on the display.
H
Now set the desired value or functional sta-
L
tus using the up
buttons.
L
During each measurement, the TP6 deter-
mines the maximum temperature value
(MAX) and shows it on the functional
temperature display
The TP6 has an individual emission factor setting and an acoustic
alarm for freely selectable upper and lower alarm limit values.
To activate or deactivate the alarm function and to set the de-
sired alarm limit values or the emission factor, navigate to the
corresponding function mode using the mode button
set the desired value or function status using the up
down selection buttons.
B 07
. The TP6 switches to the next
repeatedly until the respective
or down selection
.
Operating manual – English
These settings are stored in the device - even when it is
switched off - until the next setting change.
The TP6 has a continuous measurement function. In this mode,
the device measures the temperature continuously without the
measurement button
this function, press the mode button
corresponding function symbol
activate continuous measurement using the up
selection button.
When continuous measurement is activated, it is not
possible to change the display status of the background
lighting or laser beam display. You should therefore se-
lect the appropriate settings before activating continuous
measurement.
In order to determine measured values for different surfaces
during continuous measurement, you can set the emission
factor for the respective material at any time using the up
and down
measurement process.
and
or
having to be pressed. To activate
flashes on the display and
selection buttons without interrupting the
repeatedly until the
or down