Cleaning And Storing - Imetec Bellissima Flash&Go Pro Instrucciones De Uso

EN
of flashes. Make sure the entire area you intend to treat is covered while avoiding
to go over the same area a number of timed during the same session.
aFtEr trEatmENt
12. Press the power level setting and on/off button (5A) to switch the appliance off.
13. Remember the power level used for the treatment session as this will be reset
when the appliance is next switched on.
14. Disconnect the adaptor cable (7) from the socket.
caring for the skin after the hair removal session.
See "Other precautions for safe use".
maiNtENaNcE
WarNiNG! always disconnect the appliance from the
mains supply before cleaning or performing maintenance.

clEaNiNG aND storiNG

It is recommended to clean the appliance and the treatment surface (2) after each
hair removal session:
• Disconnect the appliance from the power supply (7) before cleaning it.
• Clean the surface of the handpiece and the treatment surface (2) gently, with a
dry, clean cloth.
• Store the appliance in a cool and dry place, away from heat and water.
56
trouBlEsHootiNG
the appliance 1. Make sure the plug (7) is inserted correctly into the power supply
does not go connection (3).
on 2. Make sure the plug (7) is inserted into a wall socket.
No light is 1. Make sure the device ready-for-use LED (5) is on so as to make sure
emitted when there is good contact with the skin and the treatment surface (2) is evenly
the treatment and firmly pressed on the skin. OR
surface (2) 2. Check the power level LEDs (5d): if one or more LEDs are flashing, it
is in contact means there is a system error. If the problem persists, contact the IMETEC
with the skin Customer Service Centre.
the appliance
has stopped
working and Press the on/off button (5A) again to switch the appliance on.
is in standby
mode
Disposal
The packaging of the appliance is made of recyclable materials. Dispose of it
in accordance with the environmental protection regulations.
Pursuant to Directive 2012/19/EU on waste electrical and electronic equipment
(WEEE), the crossed bin symbol on the appliance or its packaging indicates
that the appliance must be disposed of separately from other waste at the end
of its useful life.
The user must therefore take the appliance to an appropriate recycling centre for electrical
and electronic equipment. Alternatively, instead of handling the disposal, the user can
EN
57