Safety Lables Meanings - Hofmann monty 1270 Manual Del Operador

Part Number: EAL0408G44A
P/N: 8-23562A
P/N: 8-23562A
6
Safety Label Meanings
WARNING:
MAKE SURE THAT THE SAFETY SIGNS ARE ALWAYS
CLEARLY VISIBILE IN THE POSITIONS INDICATED BY
THE MANUFACTURER.
For any reset, use the Part Number (P/N) listed in this
charter.
EAL0408G77A
Risk of fl ying fragments during beading.
• The beading operation with the GT device can
result in fl ying objects and loud noise levels.
We therefore recommend the use of protection
equipment for eyes and ears.
• When using compressed air for the beading
operation there is the risk of the tire exploding.
• Avoid excessive pressure. Do not exceed the
maximum pressure indicated on the tire.
• The risk of explosion is also dependant on the
conditions of the tire. Check the tire before
infl ating it.
Exploding tires can cause death or serious injury.
8-23562A
Risk of electrical shock.
• Do not operate equipment with a damaged power
cord or if the equipment has been dropped or
damaged, until it has been examined by a qualified
service person.
• If an extension cord is necessary, a cord with a
current rating equal to or greater than that of the
equipment should be used. Cords rated for less
current than the equipment can overheat.
• Unplug equipment from electrical outlet when not
in use. Never use the cord to pull the plug from
the outlet. Grasp plug and pull to disconnect.
• Do not expose the equipment to rain. Do not use
on wet surfaces.
• Plug unit into correct power supply.
• Do not remove or bypass grounding pin.
Risk of electrical shock. High voltages are present within
the unit.
• There are no user serviceable items within the unit.
• Service on the unit must be performed by qualified
personnel.
• Do not open any part of the unit other than noted
and allowed areas.
• Turn power switch off and unplug the unit before
servicing.
Contact with high voltages can cause death or serious
injury.
IMPORTANT!! SAVE THESE
INSTRUCTIONS
Operator Manual