HJM 821 Instrucciones De Uso página 22

Radiador de Aceite 821-822-823-824_Maquetación 1 24/06/16 09:11 Página 22
ASSEMBLE
1. Unpack the Castor Wheels and Arc-shaped Brackets from the pro-
duct packaging.
2. Turn the radiator upside-down on a scratch-
free and stable surface to prevent damage to
the paint finish or your floor surfacing.
3. Fit the two (2) Castor Wheels onto the radia-
tor by placing the Arc-shaped Brackets bet-
ween the outermost fins on each side of the
radiator.
4. Securely fasten the two (2) Castor Wheels
onto the radiator by screwing two (2) Wing
Nuts onto each Foot.
5. Turn the radiator in upright position after the
Castor Wheel Assembly fitted. For the correct
upright position, please refer to fig. below.
CAUTION: Only operate the radiator in normal upright position
with Castor Wheel Assemblies attached to the bottom of the unit
(wheels on the bottom, controls on the top), any other position
could create a hazardous situation
OPERATE
1. Place the product in an upright position on a flat, steady, stable,
heat-resistant surface. Make sure there is nothing flammable or
heat sensitive within 1 meter (40 inches). Operating the product in
any other position could cause a hazard.
2. Insert the plug into a suitable wall outlet after turning the thermos-
tat knob counter-clockwise to the minimum position and setting the
power switches to "O" OFF. The heater is suitable for operation on
an A.C. power supply having the same voltage as that show on it's
rating label.
3. Turn the power switch knob clockwise to either "I" (Low heating) or
"II" (Medium heating) or "III" (High heating).
- 22 -
E
N
G
L
I
S
H