Futurelight DJ-HEAD 575 WASH Manual Del Usuario página 44

- Adjusting the default positions
By this function you can calibrate and adjust the different wheels to their standard/right positions. Use the
[Up] and [Down] keys to browse through the adjusting menu - the display shows step by step these
messages: "PAn, Tilt, SPEd, Colo, CYAn, MAGE, YELL, MACr EFEC, Zoom, Stro, dimr, FCAL" by which
you can adjust the fixture to the required / desired position (0-255) before the function calibration. Then when
the positioning is finished use the last "FCAL" function (Fixture calibration).
1. Calibration via the control board
Press [Enter] and the [Up] and [Down] keys in order to display the following messages: "Colo, EFEC" for
very smooth function calibration. Select one of them, press [Enter] and use the [Up] and [Down] keys in
order to adjust their right value from 0 to 255. Then press [Enter] to confirm or [Mode] to cancel and return
to the menu. This can be repeated for each calibration parameter if it is required. When the calibration is
finished, it is necessary to use the "ArES" function in order to write the calibration values to the memory
(EEPROM) and to make a reset in order to check the newly adjusted positions of the colour and effect
wheels. When the reset of the fixture is finished, the display will show the "FCAL" message. Press [Enter] to
repeat the calibration or [Mode] to return to the "AdJ" menu.
2. Calibration via the external controller
Press [Enter] and the [Up] and [Down] keys in order to display the following messages: „Colo, EFEC" -
calibration parameters. Select one of them and press [Enter].
Now you can calibrate the colour and effect wheel by your controller. The DMX calibration protocol is
described in the table mentioned below.
Personality Display
PAN-reverse
TILT-reverse
Resolution
Lamp On
automatically
Switch on/off
lamp light sensor
Display permanent
on
Display-
intensity
Display-
reverse
Feedback-
fonction
Lamp Off via
DMX
Ventilation fan
44/91
Default value
(shaded)
51839565_V_1_0.DOC