Customer Service - Solter ICON 1750 Manual De Instrucciones

Defective torch
The arc stops immediately after ignition.
CAUSE
Current T too low
start
Poorly connected earth cable
Accessories which are compatible with the equipment must always be used with the equipment. Connecting
non-compatible or defective accessories may cause serious damage to the equipment. We recommend the use
of original accessories.
List of parts. See exploded diagram in Fig. 14.
Pos. Part
1 Screw DIN 933 M6x15mm
2 Washer DIN 6798 M6
3 Washer DIN 125 M6
4 ON / OFF Switch
5 12V fan
6 Power circuit
7 Dinsel connector
8 Regulation circuit
9 Regulation label
List of parts. See exploded diagram in Fig. 15.
Pos. Part
1 ON / OFF button
2 Right side panel
3 Left side panel
4 Power circuit
5 Dinsel support
6 Regulation label
7 Right side label
8 Left side label
9 Side ventilation grille
10 Rear ventilation grille
11 Front cover
12 Screw DIN 933 M8x15mm
13 Washer DIN 125 M8
14 Washer DIN 125 M10
For all ICONTIG and ICONTIG PRO models, see the electrical diagram in Fig. 38.
All purchasers of SOLTER equipment will enjoy the advantages of SOLTER exclusive technical assistance.
In case of breakdown or technical questions contact us and our team will be pleased to deal with your requests
immediately.
SOLTER SOLDADURA S.L.
Check
Increase
Check the contact

CUSTOMER SERVICE

+34 902 431 219
Email: [email protected]
SOLUTION
Pos. Part
10 Left side panel
11 Rear ventilation grille
12 Side ventilation grille
13 Front panel
14 Right side panel
15 Cable tube
16 Ride side label
17 Left side label
18 Regulation button
Pos. Part
15 Washer DIN 6798 M10
16 Washer DIN 6798 M8
17 ON / OFF switch
18 12V fan
19 Dinsel connector 35-50
20 Regulation circuit
21 Cable tube
22 Regulation button
23 Screw DIN 933 M10x15mm
24 Bolt DIN 439 M20
25 Exterior Dinsel connector insulator 35-50
26 Interior Dinsel connector insulator 35-50
27 Washer DIN 6798 M20