Mi-T-M Corporation cm series Manual De Operation página 29

CheCKINg WATeR PumP OIl level
ImPORTANT: If oil is white or foaming, water is in the
oil reservoir. Change oil.
NOTE: Water in oil occurs as a result of spray or
condensation. Milky oil is not indicative of a pump
malfunction.
1. Put unit on level surface.
2. Oil level should be at the center of sight glass (A).
3. Add oil if necessary with SAE30W non-detergent. Do
not overfill.
ChANgINg WATeR PumP OIl
ImPORTANT: Change pump break-in oil after first 25
hours of operation and at 250 hour intervals
thereafter.
1. Place unit on level surface.
2. Run unit for a few minutes to warm oil.
3. Stop washer. Use an 22 mm deep well socket to remove
drain plug (A) to drain oil into container. Install plug.
Do not pollute; dispose of waste oil properly.
4. Remove vented plug (A). Fill pump with 11 oz. SAE30W
non-detergent oil. Oil level should be at the center of
sight glass. Replace plug.
Operator's Manual
Service
A
A
A
29