Operating Determinations; Operation: El Wire 10M - EuroLite EL Serie Manual Del Usuario

OPERATING DETERMINATIONS

This device is a lighting effect for creating decorative effects.
EL Wire 10m
The is only allowed to be operated with an alternating voltage of 230 V, 50 Hz and was
designed for indoor use only. The device may only be operated with the included power unit. The power unit
falls under protection-class 2.
EL Wire 2m
The is allowed to be operated with a direct current of 3 V and was designed for indoor use
only.
This device is designed for professional use, e.g. on stages, in discotheques, theatres etc.
Lighting effects are not designed for permanent operation. Consistent operation breaks will ensure that the
device will serve you for a long time without defects.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
This device must never be operated or stockpiled in sourroundings where splash water, rain, moisture or fog
may harm the device. Moisture or very high humidity can reduce the insulation and lead to mortal electrical
shocks. When using smoke machines, make sure that the device is never exposed to the direct smoke jet
and is installed in a distance of 0.5 meters between smoke machine and device. The room must only be
saturated with an amount of smoke that the visibility will always be more than 10 meters.
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
The maximum ambient temperature t
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like
short-circuit, burns, electric shock, lamp explosion, crash etc.
OPERATION:
EL Wire 10m
In order to design the desired patterns, draw the form onto the surface or wrap the EL Wire around the
desired form and attach the EL Wire with adhesive tape or a few drops of glue.
Connect the power cable of the LE Wire to the transformer. Connect the transformer to the mains. Make
sure that the outlet is in a dry area.
On the controller of the EL Wire, you can find a 3-step switch with the following functions:
On Static light
= 45° C must never be exceeded.
a
11/23 50520300_V_1_0.DOC