,_,WARNING:
Avoid
touching
muffler
unless
engine and muffler are cold,
A hot
muffler can cause serious burns.
_i WARNING:
Stop engine and be sure
the impeller blades
have stopped
turning be-
fore
opening
the vacuum
inlet door or at-
tempting
to insert or remove the vacuum
or
blower
tubes. The rotating blades can cause
serious
injury,
Always
disconnect
the spark
plug before
performing
maintenance
or ac-
cessing
movable
parts.
HELPFUL
TIP
IMPORTANT:
Have
all
repairs
other than the rec-
ommended
maintenance
described
in the instruction
manual
performed
by an
authorized
service
dealer.
If any dealer
other
than an authorized
Service dealer
performs
work
on the
product,
Electrolux
Home
Products,
Inc.; may not pay for repairs
under war-
ranty. It is your responsibility
to maintain
and perform
general maintenance.
GENERAL
RECOMMENDATIONS
The warranty on this unit does not cover items
that have been subjected
to operator
abuse
or negligence,
To receive full value from the
warranty,
the operator
must maintain
unit as
instructed
in this
manual,
Various
adjust-
ments
will need to be made periodically
to
properly
mah_tain your unit,
CHECK
FOR
LOOSE
FASTENERS
AND
PARTS
• Spark Plug Boot
• Air Filter
• Housing
Screws
• Muffler
CHECK
FOR
DAMAGED
OR WORN
PARTS
Contact
an authorized
service dealer
for re-
placement
of damaged
or worn parts,
• Fuel Tank - Do not use unit if fuel tank shows
signs of damage or leaks.
• Vacuum Bag - Do not use vacuum
bag if it
is torn or damaged.
INSPECT
AND
CLEAN
UNIT
AND
DECALS
• After each use, inspect
complete
unit for
loose or damaged
parts. Clean the unit and
decals using a damp cloth with a mild deter-
gent.
• Wipe off unit with a clean dry cloth.
CLEAN
AIR FILTER
Cleaning
the air filter:
:__Z_
Air
Filter
S_J_
cover
"Y/'
_I
Screws
A dirty air filter decreases
engine perform-
ance
and increases
fuel
consumption
and
harmful emissions,
Always
clean or replace
air filter after every
5 hours of operation
or
yearly, whichever
comes first.
1. Clean the cover
and the area around
it to
keep debris from falling into the carburetor
chamber when the cover
is removed,
2. Remove
parts as illustrated.
NOTE:
Do not clean filter in gasoline or other
flammable
solvent.
Doing so can create a fire
hazard or produce
harmful evaporative
emis-
sions.
3. Wash the filter in soap and water.
4. Allow filter to dry.
5. Apply
a few
drops
of oil to the filter;
squeeze
filter to distribute
oil.
6. Replace parts.
REPLACE
SPARK
PLUG
Replace spark
plug each year to ensure the
engine
starts
easier
and runs
better.
Set
spark
plug gap at 0.025 inch (0.6 mm). Igni-
tion timing is fixed, nonadjustable.
1. Twist. then pull off spark
plug boot.
2. Remove spark plug from cylinder
and dis-
card.
3. Replace
with
Champion
RCJ-6Y
spark
plug and tighten securely
with a 3/4 inch
(19 ram) socket
wrench.
4. Reinstall the spark
plug boot.
REPLACE
FUEL
FILTER
To replace fuel filter, drain unit by running it dry
of fuel. then remove fuel cap/retainer
assem-
bly from tank. Pull filter from tank and remove
it from the fuel line. Install new fuel filter on fuel
line; reinstall
parts.
-8-