Installation Requirements - Lucci fini 2100249 Manual De Instrucciones

Installation Instructions
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before using the product. Please keep instructions for future reference.
Warranty

Warranty will be void if there is any damage due to improper usage or modification to the fitting.

IN EUROPE – If you are a European customer please contact the retail outlet where the light kit was purchased for
warranty service.

Installation requirements


Must be installed by a licensed electrician.

All wiring and installation of the light fitting must adhere to local and national wiring rules.

Do not exceed the maximum wattage rating.

Select a suitable location for installation;
- This product is suitable for indoor use only.
- Ensure the fitting is not installed next to any air vents and is not in any moist or damp areas.
- The mounting point must support 2 times the weight of the fitting.

Take care not to pull any electrical wires during unpacking as this may damage the connection.

Lay out all the components on a smooth surface and make sure there are no components missing before
assembling.

Check whether the fitting has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.

Ensure power to the circuit you are working on has been switched OFF.
Installation directions
1. Remove all packaging material from the product.
2. Remove the cover from the shaft of the fan.
3. Remove the shrinkable sleeve from light wires connector (B).
4. Remove the light shade (E) from the light base (C) by pulling it to release from spring clips.
5. Connect the light wire connectors (B) together.
6. Lift and align the base of the light (C) to the light base bracket (A), let the bolt go through the big keyholes of the slot
and turn the light base anticlockwise. Align the screw holes between the light base and the light base bracket and
use the 3 mounting screws (F) to secure.
7. Install a globe (included) into the lamp holder. Do not exceed the maximum wattage rating.
8. Reposition the lamp shade using the 3 spring clips (D).
2 | P a g e