Tabla de contenido
Idiomas disponibles
Idiomas disponibles
®
Read these instructions
and this manual
in
Operator
its entirety
before you attempt
to assemble
t
or operate
your new lawn mower,
control bar
IMPORTANT:
This lawn mower is shipped
WITHOUT
OIL OR GASOLINE
in the engine.
Your new lawn mower has been as-
sembled
at the factory with the excep-
tion of those parts left unassembled
for
shipping
purposes.
To ensure
safe and
UP
proper operation
of your lawn mower, all
parts and hardware
you assemble
must be
tightened
securely.
Use the correct tools
as necessary
to ensure
proper tightness.
All parts such as nuts, washers,
bolts, etc.,
necessary
to complete
the assembly
have
been placed
in the parts bag.
_/////
/ /_///
MOWING
POSITION
//_//
Upper
handle
Handle
knob
Lower handle
TO REMOVE LAWN MOWER FROM
CARTON
1. Remove
loose parts included
with
mower.
2. Cut down two end corners
of carton
and lay end panel down flat.
3.
Remove
all packing
materials
except
padding
between
upper and lower
handle and padding
holding operator
presence
control bar to upper handle.
4.
Roll lawn mower out of carton and
check carton thoroughly
for additional
loose parts.
HOW TO SET UP YOUR LAWN
MOWER
TO UNFOLD
HANDLE
IMPORTANT:
Unfold handle carefully
so
as not to pinch or damage
control cables.
1. Raise handles
until lower handle sec-
tion locks into place in mowing position.
2.
Remove
protective
padding,
raise up-
per handle section
into place on lower
handle and tighten both handle knobs.
3.
Remove
handle padding
holding
operator
presence
control bar to upper
handle.
Your lawn mower handle can be adjusted
for your mowing
comfort.
Refer to 'AD-
JUST HANDLE"
in the Service
and Adjust-
ments section
of this manual.
TO ASSEMBLE
GRASS
CATCHER
1. Put grass catcher
frame into grass bag
with rigid part of bag on the bottom.
Make sure the frame handle is outside
of the bag top.
2. Slip vinyl bindings
over frame.
NOTE:
If vinyl bindings
are too stiff, hold
them in warm water for a few minutes.
If
bag gets wet, let it dry before
using.
\
Frame
handle
Vinyl
Frame
bindings
opening
TO INSTALL
ATTACHMENTS
Your lawn mower was shipped
ready to
be used as a mulcher. To convert
to bag-
ging or discharging,
see "TO CONVERT
MOWER"
in the Operation
section
of this
manual.
÷
388111-es-412691_r0indd
6
4_
2/23/2007
10:59:48AM
Tabla de contenido
