Amplicomms TV 2500 Manual De Instrucciones página 28

G
ETTING STARTED
Setting up an additional receiver (TV 2400-1 / TV 2410NL-1)
Your TV 2400-1 / TV 2410NL-1 is an additional receiver for your TV 2500
/ TV 2510NL. After having inserted and charged the battery you will
have to register it to the transmitter. There is no limit number of recei-
vers to be registered to the TV 2500 / TV 2510NL transmitter for use
together.
Inserting and charging the rechargeable battery
1 Insert a battery into the headset receiver.
2 Charge the battery before first use. Switch off the receiver (position OFF).
Place the receiver into the charging cradle of the transmitter. The char-
ging process starts automatically. The battery LED indicator will be red
and will turn to green when the battery is fully charged. This takes about
2 hours and 30 minutes.
Alternatively you can use the fully charged spare battery from the trans-
mitter.
Registering the receiver
1 Turn off the transmitter if it is on (disconnect from the mains).
2 Disconnect the audio source input.
3 Turn on the NEW headset, the LED indicator will be flashing on and off
slowly.
4 Press the MIC button and hold for 3s, the green LED indicator will flash
on and off quickly.
5 Turn on the transmitter immediately (must be done within 9s, or need to
redo step 4).
6 If the registration is successful, you will hear a short confirmation tone in
the headset and the green light on the headset will automatically stop
flashing and will light constantly. This indicates that registration was suc-
cessful.
7 Reconnect the audio source input.
24
Helpline UK 0844 800 6503
(See page 32 for costs and hours of operation)