V2 WES-BASE Manual De Instrucciones página 13

LED SIGNALS ON THE BASE UNIT
CONDITION GREEN LED (RADIO) RED LED (ALARM)
DIP-SWITCH 8 OFF
• Flashes slowly
NETWORK NOT
CONFIGURED
• A brief flash with
every message
received (with just
NETWORK
one sensor, the
CONFIGURED
period is 15 sec.)
• A brief flash with
every message
received
• Slow flashing until
NETWORK
at least one sensor is
CONFIGURATION
inserted in the
ONGOING
network
CONDITION GREEN LED (RADIO) RED LED (ALARM)
DIP-SWITCH 8 ON
• Channel quality
1. Channels where maximum quality has been
measured: green LED flashes 3 times
2. Channels with near maximum quality:
green LED flashes twice
NETWORK NOT
3. Channels with above-average quality:
CONFIGURED
green LED flashes once
4. Channels with below-average quality:
red LED flashes once
5. Channels with minimal quality:
red LED flashes 3 times
• Fixed
NETWORK
CONFIGURED
LED OUT 1
• Off • Off
• Fixed on if there is no • On when output
connection with a sensor
• Series of 4 flashes if the
network channel does
not correspond with
dip switch 3-6
• One, two or three • Off
flashes, depending on
the unit being
configured (button
pressed once, twice or
three times)
• Slow flashing during
network deletion (button
pressed and held down)
LED OUT 1
• Off
• Fixed on if there is no • On when output
connection with a sensor
• Series of 4 flashes if the
network channel does
not correspond with
dip switch 3-6
11
LED OUT 2
• Off
• On when output
OUT1 is activated OUT2 is activated
(sensor alarm (sensor alarm
associated with associated with
unit 1) unit 2)
• Off
LED OUT 2
• Off
• On when output
OUT1 is activated OUT2 is activated
(sensor alarm (sensor alarm
associated associated
with unit 1) with unit 2)
LED BAT LOW
• Off
• On when the LOW
BAT output is
activated (one of
the sensors has a
flat battery)
• Off
LED BAT LOW
• Off
• On when the LOW
BAT output is
activated (one of
the sensors has a
flat battery)