Acoustic Signal; Charging The Battery - Stihl AR 900 Manual De Instrucciones

2
Attach pouch to waist belt.
N
Insert the adapter (2).
N
Close the hook and eye fastener (3)
N
– the adapter is held in the pouch.
WARNING
Never transport metallic, pointed or
sharp objects in the pouch. They may
bridge the contacts in the adapter and
cause a short circuit.
AR 900

Acoustic Signal

The battery emits acoustic signals as
well as optical signals – see "Light
Emitting Diodes (LEDs) on Battery".
A
B
3
C
A A short beep
This signal is activated by pressing
and releasing the button on the bat-
tery – see "Main Parts".
Meaning: Acoustic signal works as it
should.
B Four long beeps
One LED on battery flashes green.
Meaning: Battery's state of charge is
low – recharge the battery.
C Rapid succession of short beeps
Four LEDs on battery flash red.
Meaning: Malfunction in battery –
see "Troubleshooting".
1)
Signal stops automatically after a
few seconds.

Charging the Battery

A factory-new battery is not fully
charged.
Recommendation: Fully charge the
battery before using it with your power
tool for the first time.
Connect the charger to the power
N
supply – mains voltage and
operating voltage of the charger
must be the same – see
"Connecting Charger to Power
.......
Supply".
Operate the charger indoors only in dry
locations at an ambient temperature
between 41 °F (5 °C) and 104 °F
(40 °C).
1)
Push the adapter (1) into the
N
charger (2) until you feel noticeable
resistance – then push it as far as
stop.
English
2
9