Installation And Connection; Installation - Ecler MPAGE16 Manual De Instrucciones

3. INSTALLATION and CONNECTION

3.1. Installation

Installing a MPAGE16 unit consists of the following steps:
1. Cable setup:
1
6
R
1
6
REMOTE 1
MIMO 88
1
6
REMOTE 1
MIMO 88
a. MPAGE16 control and supply bus (4 cores: CHAN H, CHAN L, +DC, GND)
must be connected to one of the MIMO88 control bus ports (REMOTE 1 or
2), in "daisy-chain" (bus devices chained in series), and the last of them
must have a 120 ohms terminal resistance between HIGH and LOW pins.
The maximum length for the control bus cable is 800 m.
b. When using two consoles connected to a single MIMO88, both can be
connected at the same port or different ones, as required in the setup. See
picture with the two options.
IN1 IN8
1
DC
GND
CAN H
CAN L
MIC +
MIC
6
IN1 IN8
1
MPAGE16 (1)
1
REMOTE 2
MIMO 88
MPAGE16 (1)
IN1 IN8
MIMO 88
6
R
6
IN1 IN8
1
DC
GND
CAN H
CAN L
MIC +
MIC
6
R
MPAGE16 (2)
MPAGE16 (2)
5