Position, Assembly And Start-Up - Ecler AUDEO106P Manual De Instrucciones

4. POSITION, ASSEMBLY AND START-UP

The following should be followed as general rules:
•
Always install the unit on hard, firm surfaces.
•
For good sound playback there must not be obstacles between the unit's position and
the audience.
•
Adjust the sound pressure levels to the playback needs. Despite its small size,
AUDEO106P has a much better performance than domestic speakers.
In the packaging of the AUDEO speakers, you will find everything you need to complete the
installation of the two units:
•
Two wall mount brackets (one per cabinet)
•
Four screws and four 6 mm wall plugs (two per cabinet)
•
Two plastic rivets to lock the loudspeakers to the brackets
•
5 mm Allen wrench
•
Two steel safety cables to prevent the speakers from eventually falling down
(one per box) with their corresponding screws and washers.
•
Two 2 terminal Euroblock connectors and a piece of corresponding speaker cable for
MASTER-SLAVE connection
•
Two 3 terminal Euroblock connectors for stereo balanced INPUT
•
Two jumpers for configuring the input sensitivity.
•
A mains cord for the MASTER unit through
•
Instruction manual
•
Warranty card
Wall mount set-up:
1. Drill two 6 mm. holes in the wall, matching the position of the bracket's holes.
2. Insert two 6 mm. wall plugs.
3. Hold the safety cable on the rear of the bracket (see diagram).
4. Place the bracket in its position, previously passing the safety cable and the signal
cable through the square hole of the bracket. Insert and tighten the screws, firmly
holding on to the wall mount bracket.
5. Connect the power cables, signal input and connection between the two units to the
connectors on the rear of the speaker. Pay attention to the correct polarity of the
Euroblock terminals.
6. Place the speaker in its final position by vertically sliding it down so that the guide on
the back fits with the guide on the rear of the bracket. Insert the plastic rivet into the
hole in the rear of the speaker.
7. Attach the safety cable to the rear of the speaker so it does not accidentally fall down
and cause material or personal damage.
8. Turn the box to the desired position both vertically and horizontally. Tighten the Allen
screws to secure this position on both axes.
To operate the speakers, turn on the MASTER (L) unit with the switch on the rear panel,
adjust the volume and equalize the sound to the desired position. The CLIP indicator warns of
power amplifier saturation due to an excess of signal. To avoid distortion and preserve the sound
quality, it is important that this indicator is not constantly lit while the unit is in normal operation. It
should light up periodically, based on the rhythm of the music's bass frequencies.
5