Toasting Instructions; Important; Removing Lodged Foods; User Maintenance Instructions - CHEF-BUILT CCT-100 Manual De Instrucciones

TOASTING INSTRUCTIONS

1. Before toasting, make sure both crumb trays are locked into position on the
bottom front of the Toaster. Both left and right toasting levers should be in the
UP position.
2. Plug Toaster into a 120V 3-prong electrical outlet.
3. Insert bread or toaster food into 1 to 4 of the toasting slot(s). Lower the
corresponding left or right toasting lever(s) until locked into place.
4. When toasting a single slice, bread may be placed in any toasting slot. Adjust the
corresponding browning control to the desired setting between 1 and 6.
5. At the end of the toasting cycle, bread or toaster food will rise automatically.
Use the high lift lever to remove smaller toaster foods or breads such as English
muffins.
IMPORTANT: To avoid damage the heating element or cause injury, never use a
fork or sharp-edged utensil to remove toast.
6. To interrupt toasting, manually raise the corresponding left and/or right toasting
lever(s).

REMOVING LODGED FOODS

1. If, after toasting, a piece of bread or any other toaster food becomes lodged in
any of the toasting slots, unplug the Toaster and allow it to cool.
2. Hold the corresponding left or right toasting lever down. Turn the Toaster upside
down and shake the food loose.
IMPORTANT: Never use a fork or sharp-edged utensil to remove toast, because
that may damage the heating element or cause injury.
3. Clean either or both crumb trays and replace.

USER MAINTENANCE INSTRUCTIONS

This appliance requires little maintenance. It contains no user serviceable parts. Do not
try to repair it yourself. Contact a qualified appliance repair technician if the product
requires servicing.
CARE & CLEANING INSTRUCTIONS
CAUTION: Be sure the Toaster is unplugged and cool before cleaning.
1.
CAUTION: Do not immerse Toaster, cord, or plug in water or any other liquid.
2.
CRUMB TRAYS: Pull each crumb tray out of the bottom front to remove. Wipe
3.
crumb tray(s) with a clean, damp cloth. Push crumb tray(s) back into position.
4. After cleaning, always replace both left and right crumb trays and check to make
sure all 4 channels are locked securely into the bottom of the Toaster.
EXTERIOR: Clean the Toaster exterior using a commercial non-abrasive washing
5.
solution, then rinse water, and last, a commercial sanitizing solution. Dampen a
clean, soft cloth or sponge with solution or rinse, then wring all excess moisture
before using.
CAUTION: Prevent liquid from running into toasting slots. Wring cleaning cloths
6.
or sponge so they are slightly damp, and NOT TOO WET.
7. Allow the Toaster's outer surface to dry before using.
TO STORE: Use the cord storage clips on the underside of the toaster. Never
8.
wrap the cord around the outside of the Toaster.
SO-315665_18073-18075_Chef-Built_Toasters_Med CCT-100_Heavy CCT-250_Sensio_IM_R05.indd 6
6
2018-09-10 10:53 AM