Residual Risk; Hazard Generated By Current; Hazard Generated By Human Error; Hazard Generated By Current During Cleaning Work - Praher Plastics EO510-ECO Manual De Instrucciones

6.

Residual Risk

6.1.

Hazard generated by current

Manipulation of the EO510ECO by operating staff is strictly prohibited and may only
be performed by duly authorized staff, qualified for electrical work. Compliance with
the corresponding instruction and prohibition signs is required.
6.2.

Hazard generated by human error

The operating staff must be instructed in regard to the residual danger resulting
from electricity and familiarized with correct operation. Efficiency of the safety
training must be verified.
6.3.

Hazard generated by current during cleaning work

Cleaning of the EO510ECO may only be performed after disconnection from power
supply (lever switch).
7.

General

PRAHER EO510ECO controls are significant technical products, which are manufactured with high
accuracy to the most modern technical production methods. Entitled complaints will naturally be
rectified as fast as possible if they occur. The equipment has a warranty after valid European law. The
warranty begins with the purchase date.
ATTENTION! Always rotate valve with manual override upon first installation or if valve has
ATTENTION! Hand tighten union nuts. Make sure that O-rings are in proper position
8.

Directions for use

The ball valve with electric actuator EO510ECO correspond to the regulations of the following
european standards:
Electromagnetic compatibility (2004/108/EC)
Low Voltage Directive (2006/95/EC)
Machinery Directive (2006/42/EC)
EN60730-1
EN55022
EN60335-1

TECHNICAL DATA

2-way and 3-way ball valve with electric actuator EO510ECO
6
not been in use for more than 2 months!
EN61000-6-3
EN61000-6-2
EN61000-6-1
ISO 16135:2006
ISO 9393:2004
ISO 9001:2008
www.praher-plastics.com