System Requirements; Safety Instructions; English - i-tec PCEGLAN Manual De Instrucciones

PCI-E Gigabit Ethernet Card
INTRODUCTION
This card is a network adaptor for desktop computers with the PCI express x1
interface offering the latest technology in the Power Management and Gigabite
Computer Network areas.
SPECIFICATION
• Chipset: Realtek RTL8111C
• Interface: PCIe x1, spec. 1.0a (up to 2.5 Gbps )
• Supported standards: IEEE 802.3, 802.3u, 802.3ab, 802.3x, 802.1Q, 802.1P,
CSMA/ CD, TCP/IP
• Network adaptor - speed: 1000/100/10 Mbps
• Support for MDI/MDI-X: yes on all speeds
• Support for Wake on LAN / Remote wake up: yes / yes
• Socket for Boot ROM: ne; Integrated EEPROM is included
• Supports Flow Control, Jumbo framework, Full/Half Duplex, Auto Negotiation
• Status indication: 2x LED diode (1000/100/10M Link/Act)
• Connector: 1x RJ-45
PACKAGE CONTENTS
• i-tec PCIe Gigabit Ethernet Card
• Low Profile Backplate
• User Manual

SYSTEM REQUIREMENTS

• DOS, OS Windows 7 / 8 / 8.1 / 10 32/64bit, Linux, Unix, Novell, Mac OS
INSTALLING THE PCIE CARD TO PC
1. Switch off the computer and disconnect it from the mains.
2. Remove the PC cover a remove the cover strip of the corresponding PCIe slot.
3. Carefully mount the PCIe card to a free PCIe slot and secure it with a screw.
4. Put back the PC cover and connect the PC to the 230V mains. Switch on the PC.

SAFETY INSTRUCTIONS

• Do not expose to extreme temperatures and air humidity.
• Use the device on flat surfaces – you will prevent it from slipping and
falling to the ground.
• Save the user manual for a possible use later.
In cooperation with the service department:
• Check functionality after falling to water or to the ground.
• Check functionality when the cover is broken.
• Send the device back if it does not work in accordance with the user manual.
FREQUENTLY ASKED QUESTIONS
Available on our website www.i-tec.cz/en/ on the "FAQ" tab of this product.
4 |

ENGLISH