Sound Adjustment - Technics SU-R1 Instrucciones De Funcionamiento

Sound adjustment

The following sound effects can be added to the audio output.
Listening to more natural-
sounding audio (Re-master)
Re-mastering expands the playback band and achieves a
higher bit depth to reproduce natural and expansive sound
close to original music.
≥ The factory default is "Off".
Press [RE-MASTER] to select "On"/"Off".
Direct mode
This unit can transmit input signals without passing them
through its digital signal processor (DSP), via the shortest
possible path. This enables faithful and high quality
reproduction of original sound.
≥ The factory default is "Off".
Press [DIRECT] to select "On"/"Off".
Setting the sampling
frequency
You can set an upper limit on the output sampling frequency
range. Please note that the range that can be processed
differs depending on the amplifier or D/A converter. For
details, refer to the operating instructions of the connected
device.
≥ The factory default is "32kHz-192kHz".
Preparation
≥ Set "Digital Output" to "On".
1
Press [SETUP].
2
Press [3, 4] repeatedly to select "D.Output
fs" and then press [OK].
3
Press [3, 4] to select an item and then
press [OK].
≥ You can select a sampling frequency of 96 kHz or
192 kHz.
20
(20)
Minimising audio distortion
If audio distortion occurs when using the analogue audio
input terminals, set the attenuator to "On".
≥ The factory default is "Off".
1
Press [SETUP].
2
Press [3, 4] repeatedly to select
"Attenuator" and then press [OK].
3
Press [3, 4] to select "LINE1" or "LINE2".
4
Press [2, 1] to select "On" and then press
[OK].
Disabling audio output
Disabling the audio output of unused terminals minimises
noise and allows playback in higher audio quality.
≥ The factory default is "On".
1
Press [SETUP].
To disable the digital audio output:
Press [3, 4] repeatedly to select "Digital Output" and
then press [OK].
To disable the analogue audio output:
Press [3, 4] repeatedly to select "Analog Output" and
then press [OK].
To disable the system terminal output (SE-R1):
Press [3, 4] repeatedly to select "Digital Link" and then
press [OK].
2
Press [3, 4] to select "Off" and then press
[OK].
≥ To enable the output again, select "On".
≥ Depending on the music source that you play back, the applied
setting may be less effective.
≥ Depending on the music source that you play back, it may not be
possible to achieve the desired audio quality and sound field
effect. In such cases, turn off this function.
≥ Both Re-master and Direct mode cannot be set to "On".
≥ When "Digital Output", "Analog Output" or "Digital Link" is set to
"Off", no sound will be output.
≥ When a headphone plug is connected, even if "Analog Output" is
set to "Off", it is not possible to disable the analogue audio output.
≥ It may take some time to output audio when you have adjusted the
audio quality.