Tabla de contenido
EN IS THERE A PROBLEM ?
PROBLEM
There is no steam.
The appliance does not
heat.
Water leaks.
Steam rate decreases.
The steam leaves stains
on the fabric or the
appliance spits
Appliance steams
continuously.
POSSIBLE CAUSES
The appliance is not plugged in, or not
switched on.
The water level is too low.
The steam pump has not been primed.
You are using the appliance for the first
time.
The water tank is not fully in place.
The appliance is on standby mode.
It is not plugged in, or not switched on.
The appliance is on standby mode.
The water tank is not fully in place or
the stopper is not closed properly.
Calc Sealing
You are using water with additives.
The appliance has not been cleaned en-
ough after the descaling operation.
You are using other liquids than white
vinegar to descale the product.
The steam trigger is on the lock posi-
tion.
SOLUTIONS
Check that your appliance is correctly
plugged in and switched on.
Unplug your appliance and refill it.
Press the steam trigger continuously for
a few seconds to begin steaming.
Press the steam trigger continuously for
a few seconds to begin steaming.
Ensure that stopper is closed and that
the water tank snaps when put into
place.
PLEASE REFER TO THE 'STANDBY'
section.
Plug in your appliance and switch on.
PLEASE REFER TO THE 'STANDBY'
section.
Ensure that stopper is closed and that
the water tank snaps when put into
place.
Refer to 'ANTI CALC section in
instructions for use.
Never add any additive in the water
tank.
Read carefully the 'ANTI CALC' section
in instructions for use.
Use only white vinegar during 'ANTI
CALC' procedure.
Unlock the steam trigger.
19
Tabla de contenido
