Newteck FRESH ESSENCE Manual De Instrucciones página 13

3. To turn off the unit and stop the air flow, press the OFF button and it will automatically reset its
position .
Cooling Function (humidification):
1. R emove the water tank from the back of the air conditioner and fill the tank with clean water. The
water level must be between the "MIN" and "MAX".
2. Y ou can add the ice packs to the water tank if you want to get cooler air. Always use with water.
The water level, including the ice packs, should be between the "MIN" and "MAX".
3. C hoose the desired speed (low-mid-high) and the unit will change to the correct position
4. Press the Cooling button
Ice Packs: The Ice Packs stay cold and slowly absorb heat from the water, thus cooling the water
temperature in the tank and blowing out colder air.
• Put the Ice Packs in the freezer for at least 6 hours.
• R emove the water tank and place the Ice Packs along with water inside.
• T wo Ice Packs are included for use according to your needs.
Aromatization of the air: Add to the tank water and fragrance before activating the conditioner,
the air will give off a light and pleasant smell to the environment. The aroma can be in liquid or solid
solution, simply add a few drops to the water, depending on the intensity of the odor you want to
achieve adjust the amount, it is advisable to start with a small amount and increase it according
to your needs.
CLEANING
• Please disconnect the unit from the power supply before cleaning.
• D o not immerse the control panel in liquid or water
• D o not use abrasive products.
Cleaning the air filter
In the back of the unit, remove the upper screw and take out the air filter holder using the two upper
grips. Separate the filter from the damp cloth.
Clean the air filter with a neutral detergent and a soft brush, it may be cleaned with water, and then
left to dry.
Replace the filter and cloth into position and screw back in place.
Cleaning the damp cloth:
In the back of the unit, remove the upper screw and take out the air filter holder using the two upper
grips. Separate the filter from the damp cloth.
Clean the damp cloth with a neutral detergent and a soft brush. Rinse with water and leave it to dry.
Replace the filter and cloth into position and screw back in place.
ATTENTION: Place the cloth correctly in position to avoid water leakage.
Cleaning the water tank: Clean the water tank with a neutral detergent and a soft brush, then
rinse with water.
Cleaning the casing: If necessary, clean the casing with a neutral detergent and a soft cloth.
to activate the air cooling function.
ALWAYS ASSURE THAT
THE TANK CONTAINS WATER WHEN USING
THE COOLING
FUNCTION, OTHERWISE
THE ENGINE WILL BURN.
13
.