Filling The Water Reservoir - Beem Samowar 2017 Manual De Instrucciones

EN
HOT Hot water
BOIL Boiling water
The control lamp (8) lights up as soon as the heating element of the device starts heating
the water. The control lamp lights up at intervals when the water is being kept warm and
when boiling at intervals.
Removing / Attaching the Lid
1. Hold the lid (12) at the lid handles (13) and pull it upwards.
If the device has been in operation, use potholders or similar gloves as the lid might
be hot. Always allow the device to cool down before using it again.
2. To close the lid, place it on the water reservoir (5).

Filling the Water Reservoir

Only ever fi ll the water reservoir (5) with fresh, clear tap water. Do not pour in any
other liquids.
1. Open the lid (12) (see the "Operation" chapter | "Removing / Attaching the Lid").
2. Pour the desired quantity of water (maximum 3 litres) into the water reservoir. Note the
MAX marking (11).
3. Close the lid (see the "Operation" chapter | "Removing / Attaching the Lid").
Operating the Discharge Tap
There are two possible ways of removing the water from the water reservoir (5) using the
discharge tap (9).
Touch Mode (Picture A1)
1. Press down the lever (10) and keep it pressed down. The discharge tap opens and
water fl ows out.
2. Let go of the lever when the quantity of water you want has been removed. The dis-
charge tap closes again.
Constant Mode (Picture A2)
1. Flip the lever all the way back. It locks in place in this position. The discharge tap
opens and water fl ows out.
2. Let go of the lever again and tip it forwards (do not press it down) when the quantity of
water you want has been removed. The discharge tap closes again.
07123_DE-EN-FR-ES-IT_A5_V1.indb 28 07123_DE-EN-FR-ES-IT_A5_V1.indb 28
28
18.06.2018 12:28:07 18.06.2018 12:28:07